Orange 5 Orange5 Programmer with Full Adapters Aftermarket

Orange 5 Orange5 Programmer with Full Adapters Aftermarket:

Orange5 Programmer is a professional general purpose programming device for memory and microcontrollers. Unique feature of the current series programmers is built-in macrolanguage for writing down protocols, which gives fast and easy capability to add new types of ICs, precisely meeting manufacturers’ requirements to read/write algorithms.

Orange5 Programmer User Manual:

Orange5 Programmer User Manual

Orange5 Programmer Features:

• Universal easy to plug panel ZIF16 for EEPROMs
• Control of contacts in the sockets
• Two expansions sockets (MT & SE)
• Protection against overcurrent
• Overload voltage protection
• Three 3 adjustable voltage and current control: Voltage of power supply ( 2.0…5.0V ), programming voltage (2.0…21.0V), additional static 10V for microcontrollers.
• High-speed bidirectional pin drivers with adjustable voltage (2.0…5.0V)
• Wave cycle generator with frequency ( up to 24 Mhz) and out voltage(2.0…5.0V) adjustment
• Capability of functional emulation of class CDC USB devices
• Built-in 32-bit virtual machine
• Supported interface: I2C, SPI, MicroWire, JTAG, UART, BDM, ISO7816, K-LINE (via adapter), CAN (via adapter)

Orange5 Programmer Software Download and installation Guide:

Download the Orange5 Programmer latest software

1. Extract the software from orange5.rar in any location on your PC
2. Open Windows device manager
3. Connect Orange-5 to PC
4. Find Orange-5 in device manager then right click properties ->Driver->Update driver
5. Navigate to driver location (where you extracted orange5.rar ) there is folder Driver [select subfolder X64 if your OS is 64bit]
6. Install the driver
7. Disconnect and reconnect the programmer in order to allow it to reinitialize.
8. Run the program (orange.exe) [depending on the USER ACCOUNT CONTROL settings of your Windows you might need to run the software as administrator ] and the programmer should initialize properly and run.
   *If you get message “Hardware not detected”, but the Mode LED on top of Orange-5 is solid blue and Orange-5 is shown normally in device manager , check your USB ports/cable (if overloaded/bad contact/etc the programmer won’t run)
   *If the MODE Led is blinking driver is not installed Disconnect and reconnect again the programmer then go back to step 2.

System Requirements:

• 32-bit (x86) or 64-bit (x64) Windows operated PC
• Supported XP, Vista for 32-bit & 7, 8, 10 for 64-bit
• USB 2.0 Cable: A-Male to B-Male Cord

Orange5 Programmer Supported Chips List:

Orange5 Programmer Supported Chip List